If your industrial wastewater treatment results in a somewhat hazy or cloudy appearance there are a number of areas you could look at for improvement.
Residual Emulsified Oil
Water that contains emulsified oil sometimes it can carry over if it isn’t tied up to your coagulant you are using. A proprietary coagulant that has a calcium, magnesium or iron component can help break the interface of the emulsion thus clearing up the water.
Hazy effluent may be caused by residual surfactants that may show up when it reaches a cloud point or interacts with other waste rinses. Choose the best coagulant based in iron or organic components to the formulation. The following would be a good starting point:
Over dosing on the coagulant
The use of a coagulant to solve a hazy condition in wastewater should be used at the dose to solve the worst condition. Too much organic components can also lead to haziness. When jar testing, try to bracket the high and low dose to find the best results that take care of the haziness.
Over dosing on an Emulsion based polymer
Polymers are typically added as a 0.1% dilution made up in a day tank prior to use. This diluted polymer is added at 5-10 ppm depending on the solids you are trying to mass together. If the flow rate goes down but the polymer dose stays up this condition can result in over dosing of the polymer. The polymer addition should be tied into the flow rate – proportionally. If this occurs cut the dosing back on the polymer.
Adding the wrong polymer
Polymers are characterized by their iconicity, charge density and molecular weight. Jar testing can determine the best polymer to use for your solids. If the polymer is not effective, you may be using the wrong polymer. Changing the dosage doesn’t solve the problem either; the polymer can also lead to haziness but will not be solved by cutting back on the dosing.
|Aquapure™ I-300||Versatile and unique product acts as a coagulant AND a metal precipitant. A blended liquid that eliminates the need for lime or other difficult to use powders|
|Aquapure™ EB||Designed to rapidly separate suspended solids from solution when combined with Aquapure AN|
|Aquapure™ ACP||Highly charged organic/ inorganic aluminum coagulant|
|Aquapure™ OB Plus||A concentrated cationic coagulant used for clarification as well as dewatering of wastewater.|
|Aquapure™ MFT||A liquid blended coagulant for settling of mixed metals. Works well with Aquapure™ P601 and Aquapure™ FW|
|Aquapure™ TH||Wide application formulation. Aluminum-based and multi-component liquid coagulant.|